Where Are the Meet-and-Greet Points at the Domestic and International Departures Areas of Antalya Airport?

Meeting your passenger at the right spot after they land at Antalya Airport is actually a simple task, solved by knowing just a few fixed references. The short answer to the question of where the meeting points are at the Antalya Airport Domestic and International exits is this: at both terminals, the meeting takes place in the public area right outside the arriving passenger exit gate on the ground floor. In practice, although landing, passport, and baggage processes vary depending on air traffic, the moment of meeting the passenger usually happens within 20–40 minutes after the plane lands. When you make a VIP transfer reservation in advance, the meeting instructions become clear, so you also reduce the invisible loss of time and cost that comes from going to the wrong terminal or missing each other in the crowd.

Table of Contents

Quickly understanding the terminal structure of Antalya Airport

Choosing the right meeting point starts with knowing which building you are talking about first. Antalya Airport today effectively has three terminals: the Domestic Terminal, International Terminal 1, and International Terminal 2. There is a recent change to note here: all international flights have been operating from Terminal 2 since October 27, 2025. In other words, if you are meeting an international passenger, you should now refer directly to Terminal 2, not Terminal 1.

The two building groups stand at different locations within the complex. The Domestic Terminal and Terminal 1 are connected to each other by a short walkway and are located in the same section. Terminal 2, on the other hand, is a separate building and is connected to the Domestic/Terminal 1 area by free shuttle services. The stops of these shuttle services are located in front of the Departures sections; if you need to change terminals, these buses are a practical solution.

In short, the starting point of your meeting plan should be this distinction:

• If a Domestic flight is arriving: Domestic Terminal
• If an International flight is arriving: Terminal 2
• Terminal 1 physically exists, but international flights are now operated from Terminal 2, not here

Clarifying this distinction from the start is the step that helps most, especially with connecting flights or the risk of terminal confusion. The starting point of the transfers we make to different regions is always this terminal distinction; we proceed with the same logic when planning our VIP transfer regions.

Meeting point at the Domestic exit

On the Domestic side, things are relatively simple. The arriving passenger meeting area is on the ground floor and is at the same level as the baggage claim area. Since there is usually no passport control for domestic flights, after the passenger disembarks, they collect their baggage and pass through the exit gate to the public arrivals hall. The meeting takes place in the area between this hall and the building exit gate, or on the sidewalk just outside the exit.

In practice, the safest reference points are the waiting areas directly across from the arriving passenger exit gate and on its right and left sides. The benches and directional signs here are the natural spots where people meeting passengers gather. Since there is a walking connection between the Domestic Terminal and Terminal 1, it is also possible to meet the passenger at the Domestic exit and, if necessary, walk a short distance to the Terminal 1 area or the parking lot.

There is an important point here: the airport operator does not publish a single named "official meeting point" for the entire terminal. Therefore, when planning a meeting at Domestic, the most sensible approach is to use fixed references that everyone can see:

• Arriving passenger exit gate
• Information desk point
• The main corridor leading from the baggage claim area to the exit

When you describe one of these three references to the passenger in advance, the meeting point will not go wrong, even if there is no phone signal.

Meeting point at the International Terminal 2 exit

Since international flights now land at Terminal 2, the meeting point for international passengers is in this building. Terminal 2's arriving passenger baggage claim and exit area is on the ground floor. After passport control and baggage claim, the passenger exits through wide automatic doors from the ground floor arrivals hall. The sidewalk and controlled vehicle lane in front of these doors is the main area used by pre-booked transfer companies and waiting relatives to meet passengers.

Current maps and field descriptions show that this lane is organized in the form of a controlled meeting line extending to the left, right in front of the Terminal 2 arriving passenger exit gates. Coordination points similar to a "Meeting Desk" are sometimes used here as a reference. However, just as at Domestic, there is no prominent, single named official "Meeting Point" sign here either; instead, the arrivals hall and information desk points serve as natural meeting points.

Therefore, the practical meeting definition for Terminal 2 is as follows:

• On the ground floor, right in front of the main automatic doors opening from the arrivals hall to outside the building
• The waiting area between these doors and the vehicle meeting lane
• A reference near the information desk that can be easily described in the crowd

When meeting a passenger, our driver usually stands in exactly this area with a meeting sign bearing a name or a company sign. The process changes depending on which region you will go to after Terminal 2; you can plan your route after the meeting in advance by reviewing our transfer destinations.

Step by step: How do you meet the passenger at the right place?

The sequence below makes the meeting process applicable by dividing it into three time periods: before the flight, the passenger's process inside the building, and the preparation of the person meeting them.

Before the flight (planning)

1. Clarify the flight number and airline.
2. Check whether the flight is Domestic or International Terminal 2 from the airport flight information screens or airline information.
3. For international flights, remind the passenger in advance: "You will land at Terminal 2."
4. Enter the flight number, estimated landing time, and passenger names correctly in the reservation; this information allows the driver to track the flight.
5. Share a simple meeting description with the passenger: for Domestic, "the waiting area across from the arriving passenger exit gate," and for International, "the VIP meeting lane in front of the Terminal 2 exit gate."

The passenger's process (from landing to the meeting point)

1. After landing, follow the terminal directions to (for international) go to passport control.
2. Collect your luggage from the baggage claim area.
3. After customs, follow the "Exit / Çıkış" directions to proceed to the arrivals hall.
4. At Domestic, continue straight from the ground floor hall and exit through the building exit gates; the meeting area is right in front of you.
5. At Terminal 2, when you exit through the automatic doors, you will see the pre-book transfer and private meeting line on the sidewalk right in front of the door.
6. After the meeting, walk a short distance to the vehicle; vehicles are usually positioned in a special lane parallel to the sidewalk or in the parking lot.

Preparation of the person meeting the passenger

1. When arriving at the airport, recheck the passenger's terminal.
2. Leave your vehicle in a short-term waiting area or parking lot; do not wait for a long time in the road lane in front of the arrivals gate.
3. For Domestic, move to the waiting area closest to the exit gate.
4. For International, stand near the controlled meeting lane in front of the Terminal 2 exit gate.
5. If the passenger is delayed, without panicking, check the "Landed / İniş" time and baggage belt information from the flight information screens; this allows you to estimate your average waiting time.

Common mistakes and solution suggestions

Going to the wrong terminal. This is the most common mistake. While the passenger lands at Terminal 2, the person meeting them may go to Domestic or Terminal 1. Solution: your default for international flights should always be Terminal 2, and confirm the terminal information from the official screen. If necessary, transfer between Domestic/Terminal 1 and Terminal 2 by free shuttle service.

Choosing the meeting point inside the building, before the checkpoint. For security reasons, waiting for a long time in these areas may not be desirable. Solution: always set the meeting point as the public arrivals hall that has passed security control and the front of the building exit gate. At Terminal 2, the outdoor sidewalk and pre-book transfer lane are more suitable for this purpose.

Relying on the passenger's phone. If roaming is off or Wi-Fi cannot be connected, the passenger will have difficulty finding the spot. Solution: give the meeting description both verbally and in writing before the flight, and use a fixed reference such as "in front of the information desk directly across from the exit gate." Adding a second contact person to the reservation also provides a backup in case of possible disconnections.

Waiting for a long time with a vehicle in front of the arrivals gate. This creates problems in terms of traffic order and security. Solution: if a long wait is needed, leave the vehicle in the parking lot, find the passenger at the meeting point first, then walk to the vehicle together.

When should professional VIP transfer be preferred?

You can also organize the meeting process yourself. But in some scenarios, professional VIP transfer clearly stands out both in terms of the clarity of the meeting point and comfort.

Family and travel with children. When there is a need for a baby or child seat, large luggage capacity, and a spacious air-conditioned vehicle, our vehicles such as the Mercedes Vito or Sprinter provide this comfort. For families with children, finding directions and making transfers inside the airport creates extra stress; door-to-door transfer removes this burden. You can compare vehicle options on our VIP transfer vehicles page.

Landing late at night or during peak season. During night hours, public transportation options may be limited; with VIP transfer, the meeting point and vehicle location are known in advance. Since the airport is very busy during the summer season, a pre-planned meeting is the most practical way to reduce chaos.

Corporate and business trips. For a guest who needs to make it to a meeting, an unexpected delay is unacceptable. Transfer with flight tracking preserves the meeting plan by automatically updating the time in case of a delay. For corporate guests, a professional meeting directly affects the company image.

Transfer to distant destinations. Travel time with transfers to regions such as Belek, Side, Kemer, Alanya, Kaş, or Kalkan may be longer. With VIP transfer, you go directly from the meeting point to the hotel or villa.

The taxi or public transport approach may be suitable for individual travelers who know the airport and city routes well, have light luggage, and are not under time pressure. However, for families with children, large groups, night landings, and long-distance resort transfers, a professional meeting is the more correct choice. To create the most suitable meeting and route plan for you, it is enough to share with us your flight terminal, landing time, and destination region.

Frequently Asked Questions

What is the shortest answer to the question of where the meeting points are at the Antalya Airport Domestic and International exits?

For Domestic, it is in front of the arriving passenger exit gate on the ground floor; for International, it is the sidewalk and pre-book transfer meeting lane just outside the arriving passenger exit gate on the ground floor of Terminal 2.

Is there an official, single "Meeting Point" area at the airport?

A single named official "Meeting Point" is not specified in passenger information. Instead, the arrivals hall, information desk points, and building exit gates at each terminal are used as natural meeting points.

How do you get from Domestic to International Terminal 2?

There are free shuttle services between Domestic/Terminal 1 and Terminal 2, departing from in front of the Departures sections. You can transfer between terminals with these buses.

What should I do if the passenger's terminal changes at the last minute?

First, confirm the new terminal from the flight information screens, transfer to the correct terminal by shuttle service if necessary, and update your meeting description according to the new terminal.

How should the meeting point be arranged for guests with limited mobility?

There are accessible exits with elevators and ramps on the ground floor of both terminals. The most practical approach is to set the meeting point as right in front of these exit gates or the nearest wheelchair-accessible sidewalk section.